WEEK SIX

We began building the circuits using the Arduino kits and also looked for ways to harness electricity into the circuits. The circuits was not completely built because we did not have enough knowledge on how to build the circuits. So, we continued our research and sought help from the co-op on duty. We needed the circuits to serve as a medium for power distribution into the separate components of the project design. The pneumatic cylinder and linear movement actuator was our first target.

The diagram about shows how the circuits are to be connected and how power is being harnessed from two 9 volts batteries. 
Furthermore, below is a video we watched on how to make a simple circuit using a breadboard and a Arduino Uno kits.